Nine out of ten HVAC system failures are caused by dirt and dust. Your air conditioner is responsible for 60% of your bill.
The most important things you can do for your HVAC system are to keep it clean and have it serviced every season. Regular maintenance will help improve the performance of your system, extend its life, and help you avoid the need for repairs. Our preventative maintenance plan will help you take care of your HVAC system with little to think about.
With Your Membership, You Get:
Both, AC & Heating Systems "Tuned Up" 2 Times a Year
- 23 Point Heating Diagnostics ($189 value)
- 22 Point Cooling Diagnostics ($189 value)
- Replace CO Detector as needed ($222 value)
- A/C Condenser Cleaning ($125.00 value)
- Furnace Cleaning ($125.00 value)
- Condensate Drain Line Cleaning ($159 value)
- Service Reminders
- Discounted Repairs
- Discounted System Enhancements
- Top Priority Service
- Repair Warranty (1 year on labor)
- No service call fee with repairs over $300.00 ($75 value)
- Standard Rate Emergency Service ($114 Value)
- Protective Coating for A/C
- Inspect for air leaks at unit
- Check Static Pressure ($185 Value)
- Total Savings per unit $1,383
- Inspect condenser fan and fan blades for stability and damage
- Inspect service disconnect and fuses
- Check amperage draw of condenser motor and compressor
- Check crankcase heater operation for heat pumps
- Check refrigerant levels and system pressures
- Check contactor and capacitor
- Check belts and pulleys and adjust when accessible and applicable
- General inspection of wiring (indoor and outdoor units when applicable)
- Visual inspection of filter(s); replace if Homeowner has replacement filter readily available
- Check accessible condensate drain lines and drain pans for leaks or stoppages (additional charge for rerouting if necessary)
- Check indoor / outdoor motor bearings and wheel
- Lubricate motors and other moving parts when applicable and necessary
- Test temperature rise and drop for heating and cooling
- Check general heating operation
- Test defrost cycle when applicable (heating)
- Check gas pressure when applicable (furnace)
- Visual inspection of furnace, furnace chambers and / or heat exchanger when applicable
- Check and if necessary clean burners (furnace)
- Visual inspection of accessible flue pipe(s) (furnace)
- Check amperage draw of indoor blower motor ü Inspect pilot system (furnace)
- Check controls and safeties on furnace
- Inspect indoor and outdoor coils for restrictions and/or damaged fins when accessible and applicable
- Inspect accessible ductwork for visible tears and/or leaks
- Check for carbon monoxide when accessible and applicable